WD-40 Contact Cleaner 400ml

A product that cleans oil, dirt, flux residues, and condensation from sensitive electronics and electrical equipment. It quickly penetrates hard-to-reach areas and dries fast without leaving residues. WD-40 Specialist Fast Drying Contact Cleaner can be used on electronic equipment, contacts, plastics, and rubber.

Features and Benefits:

Dual-action Smart Straw applicator for large areas and high-precision spray applications.
Fast-acting non-conductive cleaner.
Perfect for cleaning electrical equipment, contacts, plastic, and rubber.
Penetrates quickly and leaves no residue.
Penetrates hard-to-reach areas.
NSF: K2 registered #145372
Typical applications:

Electrical modules, circuit boards, controllers, printers and copiers, switches, tape drives, and precision instruments. (For all precision instruments, please check with the manufacturer.)

Instructions for use

Isolate all power and allow all hot surfaces to cool. Ensure all stored power is drained from the system. Shake the can well. Hold the can 15 to 20 cm away from the surface and spray directly onto the electronic device or circuit board to eliminate and remove any contaminants that may cause loss of electrical contact. Tilt the surface during cleaning so that all excess cleaner can drain off. Allow the product to dry completely and thoroughly ventilate the system before restoring power.

 765 Product Facts

Safety Data Sheet